Is a tripping circuit breaker dangerous? +
A circuit breaker that trips occasionally is doing its job — protecting you from overcurrent. However, frequent or immediate tripping indicates an underlying fault such as a short circuit, overloaded ring main, or deteriorated cable insulation. Do not simply keep resetting it, as this bypasses the protection that is keeping you safe. Have an electrician in Attleborough diagnose the cause before using the circuit again.
Can I do any electrical work myself? +
You can legally carry out minor electrical work such as replacing light switches, sockets (like-for-like), and light fittings without notifying building control. However, you must not add new circuits, work in bathrooms or kitchens (within zones), replace a consumer unit, or install outdoor wiring unless you are Part P registered. DIY electrical work is a leading cause of house fires — if you are unsure, always call a qualified electrician in Attleborough.
What should I do if I smell burning from a socket or switch? +
Switch off the circuit at the consumer unit immediately and unplug everything from the affected socket. Do not use the socket again until it has been inspected by a qualified electrician. A burning smell from electrical fittings usually indicates overheating caused by loose connections, overloaded circuits, or deteriorated wiring — all of which are fire hazards. Call an emergency electrician in Attleborough straight away.
My RCD keeps tripping — what should I do? +
An RCD that keeps tripping is detecting an earth leakage fault, which could be a sign of damaged wiring or a faulty appliance. Start by unplugging all appliances on the affected circuit, then reset the RCD. Plug each appliance back in one at a time to identify the culprit. If the RCD trips with nothing plugged in, the fault is in the fixed wiring and you need an electrician in Attleborough to trace and repair it.
Do I get a certificate after electrical work is completed? +
Yes — for any notifiable electrical work (new circuits, consumer unit replacements, bathroom/kitchen installations), your electrician must issue an Electrical Installation Certificate and notify your local building control. For smaller jobs like replacing a socket or light fitting, you should receive a Minor Electrical Installation Works Certificate. Keep these certificates safe as you will need them when selling your property.
Why do my lights flicker in Attleborough? +
Occasional flickering is usually caused by a loose bulb or a poor connection at the light fitting. Persistent flickering across multiple lights can indicate a loose neutral connection at the consumer unit, a faulty main switch, or an issue with the incoming supply. If all lights in your home flicker simultaneously, this could be a supply-side issue — contact your DNO first. Otherwise, have an electrician in Attleborough check the connections at your consumer unit.